New Sopris Rookie Lite
#14
I took the "stuffing" out because I needed to tape the seams inside the cylinders. (due to cuben/DCF material used).

Here is a pic of the Sopris "stuffing" - it consists of:
*foam tube with rigid tubing inside
*foam tube is then rolled in one layer of ?closed? cell foam
*2 ?closed? cell foam end caps, tapered.

   

My "stuffing" consists of just:
*larger diameter foam tube, no rigid tubing inside
*1 of the sopris ?closed? cell foam end caps, tapered.
*Foam tube is then rolled in 1 layer of bubble wrap

I'm not liking my stuffing, the foam tube I used is a bit too rigid I think.  Will be fussing with this as time allows.

   
Reply


Messages In This Thread
New Sopris Rookie Lite - by Kat - 05-11-2018, 08:30 PM
RE: New Sopris Rookie Lite - by Nanno - 05-11-2018, 11:13 PM
RE: New Sopris Rookie Lite - by IdahoNancy - 05-27-2018, 04:05 PM
RE: New Sopris Rookie Lite - by Kat - 05-27-2018, 04:18 PM
RE: New Sopris Rookie Lite - by IdahoNancy - 05-27-2018, 07:29 PM
RE: New Sopris Rookie Lite - by Taffy - 05-28-2018, 12:21 PM
RE: New Sopris Rookie Lite - by Kat - 05-28-2018, 05:24 AM
RE: New Sopris Rookie Lite - by IdahoNancy - 05-28-2018, 08:54 PM
RE: New Sopris Rookie Lite - by Nanno - 05-29-2018, 07:41 AM
RE: New Sopris Rookie Lite - by IdahoNancy - 06-01-2018, 09:19 PM
RE: New Sopris Rookie Lite - by Nanno - 06-02-2018, 06:35 AM
RE: New Sopris Rookie Lite - by Kat - 06-27-2018, 04:43 AM
RE: New Sopris Rookie Lite - by Nanno - 06-27-2018, 10:31 AM
RE: New Sopris Rookie Lite - by Kat - 06-27-2018, 11:17 AM
RE: New Sopris Rookie Lite - by Kat - 07-26-2018, 06:59 PM
RE: New Sopris Rookie Lite - by Ms_Mudd - 08-16-2018, 11:14 PM
RE: New Sopris Rookie Lite - by Kat - 08-17-2018, 04:39 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)