New Sopris Rookie Lite

[Kat]

I took the "stuffing" out because I needed to tape the seams inside the cylinders. (due to cuben/DCF material used).

Here is a pic of the Sopris "stuffing" - it consists of:
*foam tube with rigid tubing inside
*foam tube is then rolled in one layer of ?closed? cell foam
*2 ?closed? cell foam end caps, tapered.

   

My "stuffing" consists of just:
*larger diameter foam tube, no rigid tubing inside
*1 of the sopris ?closed? cell foam end caps, tapered.
*Foam tube is then rolled in 1 layer of bubble wrap

I'm not liking my stuffing, the foam tube I used is a bit too rigid I think.  Will be fussing with this as time allows.